Signode BXT2 Instructions d'exploitation télécharger pdf (Page 27)

ak 3.11

27

BXT 2 BXT 2-19

E32

DRIVE_TIMEOUTERROR

Description:

Time out in communication with power electronics.

Possible cause:

• Power electronics is not switched on by the PCB

• EMV-Disorder

• Hardwarefailure, faulty wiring

Rectification:

1. Check the wirings power electronics to PCB

2. Replace the PCB (Pos. 198)

3.

Replace the power electronics (Pos 212)

Interruption

Current process is

interrupted. Tool is in

standby mode again.

E33

DRIVE_OVER

TEMPERATURE

Description:

Over-temperatur of power electronic.

Possible cause:

• End-phase-temperatur above 105°C

• End-phase-temperatur sensor defective

Rectification:

1. Let tool cool down

2.

Replace the power electronics (Pos 212)

Interruption

Current process is

interrupted. Tool is in

standby mode again.

E34

DRIVE_UNDERVOLTAGE

Description:

Under-voltage at drive end-phase

This error code is bypassed to E23

Possible cause:

• Temporary voltage drop (<8.5V) caused by high

current consumption

• Empty battery during operation

Rectification:

1. See failure code E23

Interruption

Current process is

interrupted. Tool is in

standby mode again.

E35

DRIVE_OVERVOLTAGE

Description:

Over-voltage at drive end-phase

Possible cause:

• Batterie-voltage to high >24.5V

• Voltage peaks

• Voltage measurement on end-phase defective

Rectification:

1. Replace Battery

2.

Replace the power electronics (Pos 212)

Interruption

Current process is

interrupted. Tool is in

standby mode again.

E36

DRIVE_COMTIMEOUT

Description:

Communication time-out with Controller (PCB).

Possible cause:

• Wiring faulty

• Hardware defective

Rectification:

1. Check the wirings power electronics to PCB

2.

Replace the PCB (Pos. 198)

Interruption

Current process is

interrupted. Tool is in

standby mode again.

E37

DRIVE_CURRENTLIMIT

Description:

Short circuit (Overcurrent) during welding

Possible cause:

• Tool is blocked during welding

• Current measurement on on the power electronic is

faulty.

Rectification:

1. Clean the tool, remove blockade

2.

Replace the power electronics (Pos 212)

Interruption

Current process is

interrupted. Tool is in

standby mode again.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Commentaires sur ces manuels

Pas de commentaire