Signode BXT2 Instructions d'exploitation télécharger pdf (Page 21)

ak 3.11

BXT 2 BXT 2-19

11. Wiring

The cables must be layed very accurate. Misplaced wiring could be damaged by moving parts inside the

tool. Bad connections may lead to tool malfunction.

1. Prepare the power electronics for the assembly.

Connect the hall sensor cables and the signal cable to

the power electronics.

3. Mount the right half of the housing to

the tool mechanics. Insert the contact

plate with spring (Pos. 168) Take care

.that the cables are laid accurately.

2. Insert the power elec-

tronics .into the right half of

the housing. Place the wires

according the picture. Don’t

forget the seal.

4. Mount the left side of

the housing and screw

them together. Place the

wires as on the picture.

5. Plug the motor cables. You

don’t need a cable strap as the

motor housing prevents them

from disconnecting.

Place the signal cable and the hall

sensor wires as on the picture.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Pas de commentaire

Signode BXT2 Instructions d'exploitation Page 21